Pontiac: Le Mans GT-37

 This is a 1970 1/2 Pontiac GT-37 A-body
-Likely one of 4 with stripe/wing color combo
-Repainted factory Canyon/copper
-Factory spoiler car-1 of 137
-Bayonet stripe-only last 200 of 5820 came with these
- 15x7 Steel wheels and poverty caps
-15" repop Coker biasply G70's on the rear. 70's on the front
-Interior mostly original with a refinished dash pad and new floor mat
-Has hole in headliner and wavy door panels.   New ones will go with the car when sold.
-V. D. O. playback tach
-Autometer oil. ater. uel pressure sportcomp gauges
-New wiring harness front too back.

ENGINE

-455 H. O. 4 bolt block (date coded too 31st/69)
-4. 5" stroke eagle forged crank
-6. 8" Eagle H-beam rods
-. 045" Ross pistons. 7cc dish. 0. 59 compression
-Kaufman racing engines 300cfm D port heads
-Harland Sharp 1. 65:1  roller rocker arms
-Custom ground Isky solid flat tappet core 244@. 050 - . 550 lift
-Crane custom length 1 piece composite pushrods for custom cam
-Edelbrock dual idler gear drive
-Coated Holley street dominator intake
-850cfm Quickfuel Q-series carb
-Full MSD ignition/distributor. laster coil. AL box etc.
-Hooker super comp coated headers
-3" mandral bent exhaust with 3" inlet dual tips
-Moroso vac pump with regulator
-Full circulating fuel system-8AN throughout
-32 gallon fuel cell in sealed off trunk area
-Carb shop super blue pump (160 GPH)
-Mallory billet fuel filter
-4 core brass rad
-2-3000cfm electric fans
-Custom aluminum pulley's
-Hi-torque starter

Transmission

-Richmond gear/Doug Nash 5 speed/overdrive trans.
-Long shifter with custom heavy linkage. ount. and stick too accomodate bench seat
-Custom Z bar and heavy pushrod
-Mcleod bell housing and block saver plate
-Centre force Dual/friction clutch
3. 5" driveshaft with 1350 series yokes and u-joints


Rearend/driveline

-12 bolt diff. housing all welded up and solid with Ford big bearing ends
-Moser axles. olid pinion spacer. oser support cover
-Eaton locking diff. with 3. 73 gears
-4 wheel disc brakes with master from a vette
-12" front rotors-1LE cop package
-B body spindles-lowers car a half ich and improves steering geometry
-All new steering/suspension components throughout
-1. 25" swaybar withclose ratio steering box both from Trans am
-11. 25 rear rotors also from a Trans am
-Custom adjustable upper arms
-Lower arms are Southside machine lift bars 

I am selling for a friend so if you have questions it might take a day to get back too you but ask away.  

Also published at eBay.com

Want to buy this car?