GJN994Y

Please not no tax or mot buyer must collect for tow. Cash on collection only no paypal It pains me to have to do this but I'm going to have to put my mini up for sale due to needing money to pay off debts.

Right. I fully restored it in September 2010 I've got bills adding up to over £3000 and that's without the body and paint work and I bet you would never see another mini with the same colour's.

I rebuilt the engine to a high quality standard. it didn't need doing as it only done 28k miles but I did it anyway. I replaced the big end bearings. thrush washers. piston rings. re-grinded all the valves. replaced the single valve springs with double valve springs. cam followers. duplex timing chain and all gaskets and seals. While I was doing it I replaced the cam with a piper 276 high lift cam with the intensions of putting a race head on. so it's all ready to just swap the heads over. it also had a new clutch. It was tuned on the rolling road and had 54. 4 BHP / 6047 1min (82mph) 55. 4lbft / 4211 1min.

I had a speedo put in that was showing zero millage after the restoration so the millage shown is since the rebuild.   

When I rebuilt the car I replaced a lot of things I'll try and list them all but I'm sure to miss something but I have receipts for everything.

Stage one kit-which is 3 into 1 straight threw exhaust. heated manifold. k&n air filter and a needle 

All new spax with adjusta ride

Brand new clutch and brake master cylinders

Fronts converted to disc's which I rebuilt with all knew bearings. pistons. seals. bleed nipples discs and pads

All new rear brake set up with new brake fluid pipes and bearings

I fully repaired and painted the mini myself as it's what I do for a living at Fords. The only major bit of rust was on the rear boot hinge panel which I cut out and replaced with a new panel.

 I've under seald the whole underside.

I've fitted some recaro's recliners which I had to make a set of tilt and slide sub frames for so the back is still accessible. I payed for some diamond stitched door cards and a parcel shelf cover. I made a dash and covered it in the same material as the rest of the intoner.

It's wearing a set of 13x7 deep dish mini lights with four tyre's with good thread.

I've had every chrome bit powder coated black

Fiberglass bonnet and wheel archs

It has a slight bit of damage on the front of-side where someone caught the wheel arch while it was parked outside my house

It doesn't have a MOT or Tax as it's been off the road for about 6 months due to insurance reasons.
here's a link to my photo bucket which has pictures of the whole restoration as there is far too many pictures to put on here

Car
http://s801. photobucket. com/albums/yy296/JoneseyBoyy/Mini%20Project/

Engine
http://s801. photobuc. . /Mini Engine/

Want to buy this car?