1938 Chevrolet 5 window coupe Prostreet project All steel

1938 Chevrolet master business coupe pro-street project. All steel. fenders body. trunk lid. Have new smooth running boards. Car has had a lot of work done but has a ways to go. Make a great race car. Was building for a street car and only selling to go after another opportunity. interested in selling only no trades. Will answer all questions and send pictures at request. Steel body and fenders body will need lower quarter patches . rockers and minor rust repair on fender repairs. Normal for a car this age. Normal restoration body work needed as any quality paint job to last Fenders. hood and grill shell . all sand blasted and paint in epoxy primer ready for bodywork. The rest of the car was striped and treated years ago and sprayed with lacquer Primer. I would strip it down to bare metal and prep as you would any professional job. Has fiber glass tail piece that I would replace but you wouldn't have too. All patch panels are available from EMS I have all trim and garnish moldings some stuff has been re chromed. Most everything if not everything is here. Complete wiring harness Chassis engineering Inc. Complete bolt in suspension with upgraded arms. All prepped paint and assembled and installed. $2400 Engine and mounts in for Small block and 700R4 customTrans mount . Included 350 4 bolt main block. 40 over and all machine work done ready for building. 327 Large journal steel crank polished with bearing (STD) cast pop up pistons and stock rods. 700R4 30 spline transmission included( was told it works but would rebuild for use) Steering column mounted and all linkage complete and mocked up. It's a Steering rolling chassis. seats mounted all metal work on floor done but not final finish work (seem sealing so on. ) Small are in truck needs finished and not complete as wanting to install metal trunk pan as discussed. Brake pedal mounted and and master cylinder . (Non power master cyl and non power steering rack) Needs brake lines and fuel lines lots of little finish work (minor) and a chassis detail. seem sealing so on. 12 bolt chevelle rear narrowed with 4:10 gear and lock rite. Strange or moser axles( can't remember) axles with ford big bolt end bearing. Stock chevelle drums modified to fit. All complete and just needs lines. Ladder bar suspension. high dollar 12 position adjustable shocks. Pan hard bar. Roll bar and custom rear chassis. Needs final adjustments prep and paint. Weld Rodlite wheel 14" X 15 on rear and 31/2' x 15 on front. New front tires and rear tires are almost new Custom rear fuel cell and straps most of the chassis floor is completed fabrication wise. The car has many things done but is a project that is half done at this point.

Also published at eBay.com

Want to buy this car?