Plymouth : Barracuda Cuda

 1970 Moulon Rouge(panther pink) Cuda custom 472 HEMI. 4 speed. 4. 10 gears. This car does not need much. It will come with 2 hoods. a factory RT style hood. as well as a custom fiberglass AAR style 6" scoop hood. This car was previously restored many years ago.   I pulled a 383 out of car. had this Hemi built. note this is not a low compression mp crate motor. This car is straight. it drives great. it will bring a huge smile to your face. You can have the value of a big block Cuda. with the added value of the HEMI.

This car has one rip in back seat on a seam. and minor tear on side of drivers seat. the dash board and door panels and carpet are amazing. The original wood grip for shifter is in console. The wood grain on console and dash are really good. but do show some wear in a couple spots.

Body is straight. no major damage that I am aware of. floor of trunk is better than most. but shows some age and rust. the floor pans in car still have undercoating with no obvious issues. New MH wiring harness for engine compartment and front lights. factory ignition box and voltage regulator and correct ballast resistor are in place as well with wiring for dual chokes for a correct dual quad intake set up if future owner desires. no missing or cut wires under hood.

26" 4 row aluminum radiator. aluminum shroud. dual electric. thermostatically controlled fans.

new 8" brake booster and master cylinder and relocation brackets for hemi

TTI long tube ceramic headers. mated to 2 1/2 exhaust with flowmaster super 10 mufflers and 2 1/2 tail pipes. have original tips with car but not on car at time.

MSD 6al Ignition Box

MSD pro billet distributor. with msd wires

Holley Electric fuel pump

Adsjustable fuel regulator. nbsp; 1050 quickfuel carb( also have 2 new 850 quickfuels that will go with car in case you want to run a dual 4 intake in future.

Motor has Alluminum Big Valve CNC heads

Complete Indy Roller Rocker set up

Smith Bros Push Rods

11:1 forged Pistons

Comp Cam Hydraulic flat tappet 292

new steel flywheel

new mccleod clutch

new u joints

new eaton true trac 4. 10 gears new axle bearings and seals. also have set of used 3. 23 that will go with car.

I am selling this car AS IS WHERE IS. nbsp;no warranty expressed or implied.

This car is a nice CUDA. it's not a resto mod rebadged barracuda. or a barracuda rebadged to be a  hemi cuda clone. tribute. etc.

Its a REAL BIG BLOCK CUDA. that has had a Hemi installed.

The whole drivetrain has had 300 miles put on it since being done.

I also have a set of fabricated aluminum valve covers. extra valve cover gaskets. extra header gaskets. extra collectors. and some odds and ends. All will go with the car.

Thanks for bidding! If you end up being the winning bidder. your going to enjoy your new ride!

Also published at eBay.ca

Want to buy this car?