1970 Dodge Coronet

Selling my 1970 super bee. It is a 383 four speed pistol grip open differential car. Here is a list of the new parts that have been installed on the car. both rear quarters trunk drops full trunk pan rt side door skin all door hinges full front to back dual flow master exhaust gas tank with sending unit front gas shocks rear air shocks aluminum radiator water pump fuel pump oil pump clutch pressure plate throw out bearing turned the flywheel edelbrock carb complete valve job with hardened seats both u joints replaced drive shaft was balanced etc. I bought this car 3-4 years ago and was told that it is a one owner 33000 mile car. The first picture shows the car when I first got it.  It had been stored since 1983. It had one soft rear rail and I had both replaced. I just put the motor and trans back in and the car fired right up.  When I put the motor and trans back in I must have missed a wire or fuse. I had to hotwire the coil and start the car off the solenoid. It started  off the key before being taken apart so I know it works as it should. all glass is there but the front windshield. I found and installed a nice decklid on the car. The pistol grip shifter is there but someone took the plastic pistol grip pieces. The top plate is still there. Dash is in good shape. it will need some plastic trim pieces. Both the front buckets and rear seats are present. They will need to be recovered. The door cards are there. Dash pad looks good. There is an extra floor shift steering column with  a black oem steering wheel. The car has been metal worked from the doors back. The left fender is good. small dents and scratches. right fender has a patch cut for the top of fender. there is a replacement fender included. The hood is nice. needs cleaned up. The car has 15 inch steel wheels with dog dish hubcaps. The front and rear bumpers are there but Both need to be re chromed. The floor and rocker panels are original and in great shape. You can still read the factory stamp on the front rails.  There are two rear finish panels that will need to be cleaned up. Both the front and rear window channels are in nice shape.  Both the vin and trim plates are there. The engine compartment will need to be refinished. the car will need a new z bar as the one on it has been modified. it works but is not the right one.  I am selling the car as a non matching motor as I cannot find the vin stamp on the block. If it turns out to be right it just went up in value. You are welcome to come inspect the car during the auction. This is a 46 year old car that needs to be finished. I believe that everything I got with the car is still there but there may be some parts missing. This is a very solid car has had all the hard fabrication done. I have a New York transferable registration in my name for the car. Please call me with any questions @7163382468. As always I retain the right to end auction as car is listed on other venues. Shipping is the buyers responsibility. If you are looking for a super bee to restore than here it is. I would like car picked up in seven days as I need the room. A $500. 00 deposit via paypal is due within 48 hours of close of auction. Balance to be paid in cash on pick up . I cannot accept paypal for the whole purchase price. Thanks for looking and reading the listing. Bruce

Also published at eBay.com

Want to buy this car?