1941 Chevrolet Master

I have a 1941 Chevrolet business coupe (custom street rod) for sale, I'm selling only because I have too many projects going on. This car has been sandblasted and epoxy primed (professionally). The underside of the floors and the frame has also have been epoxy primed and painted black. The body has many custom modifications including: a chopped roof and garnish moldings, hood has been pie cut, rear fenders have been widened to run a 11.5"-12" rear tires and welded to the body, deck lid has hidden hinges and the corners have had a radius put on them vs the standard Sharpe corners, floors, rockers have been replaced as well. N.O.S. front fenders! The frame has been reinforced and a front mustang II frame has been installed with a manual steering rack and dropped spindles. Its set up for a small block chev motor and auto transmission it has a 12 gallon fuel cell that can be easily removed with a few bolts. It comes with (2) ford 9" rear end's. The one that is currently in the car has gears and axle shafts (this axle we were going to do a 4 link but didn't get a round to finishing it.. its only mocked up, The other rear end comes with the leaf springs which will still bolt right up if you want to run that set up (see pictures) There is no body filler in the body at all, The only part that body work was done was the hood. some finish welding needs to be done to the trunk lid and the inner trunk lip (see pictures of these areas). Everything that is pictured is included. I also have these parts that are not pictured because they are boxed up but they are included as well: used rear window, lots of new weather stripping, inner front fenders (painted), horns, front coil springs, grille trim parts, front and rear bumper brackets. wing windows (need to be chopped) I wasn't going to run them seeing that we were going to do a one piece glass for a cleaner look. Speedo, and other gauges, top fender trim, wiper arm assy's, headlamp buckets, inside & outside door handles, latches, locks, window crank handles. The car will NEED the following: seats, steering column, motor/trans, radiator, wiring, glass which is all flat besides the rear window that's included, body/paint, and interior. This car has had tons of hours invested into it and thousands of dollars. If you want a car to turn heads this could be the one, put your finishing touches on it! Most of the hard work is done!! I'm not desperate to sell it so I will ignore any low ball offers, I will help load the car onto a transporter if need be or you can pick the car up at my place which is soulth of Mpls Mn about 30 mins. I can refer you to the trucking broker that I have used in the past as well.

Also published at eBay.com

Want to buy this car?