1962 356 Porsche race car

 I have retired from racing. I have raced this car for the last 10 years in the SCCA vintage class and with VDCA. I also raced the car at Daytona in the Rennsport III event. The car was originaly converted to a race car in the 80's. I have log books back to 1997. This is a fully equipped race car ready to race. A fun to drive reliable track car. Not streetable as is. All the usual suspension modifications with a wonderful  non syncromesch. limited slip transaxel. and a race modifed 912 motor. 356 C disc brakes with 6in. Fuchs with Toyo  R888 205x50 racing tires with only 3 race weekends of wear. All windows are plastic except the windshield. the interior has been modified as you can see from the pictures.   It has a Kirky race seat and a modified dash with non Porsche instruments. Tthe roll cage is a very sturdy bolt in. The car has all the required safety equipment and is 12volts. More details are available if desired.

Additional details:

Body- Mild rear wheel flairs. Fender was just re shaped.
           Custom engine lid hinges. Allows "pull off" lid removal or lid can be laid back on rear window for easy engine access.
           Plastic door windows to keep the weather out when not racing.
Interior-Stock headliner.
             5# fire extinguisher.
             Aluminum cover over back seat area.
             Engine turned dash.
Chassis-Weight balanced.
              Vic Skirmats heavy duty front spindles with 3degree negative camber.
             19mm adjustable front sway bar.
             Adjustable rear spring plates set at 3 degree negative camber.
             Rear Z bar.
             Front and rear Koni shocks.
             Set up for front oil coolers on each side.
Brakes-Hawk blue pads front and Carbotech in the rear.
            All backing plats removed.
             911 master cylinder.
Transaxle-- 4 speed close ratio with Quaf limited slip.
                  Shifts very quickly.
                  Kennedy clutch.
Engine-Miniature Heim joints on all throttle linkage.
             Deep oil sump and skid plate.
             912 case. crank and rods.
             Engine designed to run up to 7000RPM.
             Ported 912 heads with Norris springs and light alloy spring retainers.
             Custom made cam for good low end torque and peak power at 6500RPM.
            86mm bore with 10:1 forged pistons.
             Electronic ignition.
             Full flow oil filter and cooler.
 

Also published at eBay.com

Want to buy this car?