1930 Hudson Street Rod G80

    This show quality. high visibility. custom. 1930 Hudson Street-Rod. is Street Ready and a nice 383 - GM Stroker Motor 410 HP. It features all the premier equipment that a quality street-rod would have.  It's show winning appearance has been a favorite of many car shows in the Pacific Northwest.

             Complete Build Sheet and Features are listed below and areavailable through the e-bay contact seller. via e-mail if requested. The professional appraisal is also available.

           If you're looking for a high visibility. reliable. Saturday Night Special. then this may be your ride

           This car has no Warranty. and will not be released until all funds and paper work have cleared

                                                        Shipping will be paid for by the buyer

                                      Someone will buy this top notch ride soon

                                                                Will it be you ?

Street Rod Features & Build Sheet

Body:

l 1930 Hudson 3 window Coupe  (Acid dipped ) with (Etched primer and sealer) Finished Color is PPG. Banana Pearl

l 3-1/2” Chop

l Filled top. Steel

l 32 Ford Radiator shell. and a Dan Fink Stainless Steel Grill

l Fenders are Fiber Glass. with modified rear fenders.

l . 062 thick New Fire Wall . with a distributor recess cove built in.

l Shaved door handles with Key-less entry

l Electric windows and door locks

l Custom Dash. with overhead mounted Classic Instruments Gauges

l Steel running Boards

l Shoulder Seat Belts. with welded frame supports in the B- pillar for safety

l Flush mounted LED fender turn signals front and rear

l Electric Antenna

l Electric trunk lid lift

l Locking fuel access door ( passenger side ) with a 15. 5 gal fuel tank

l Vintage Air. heater and ventilation sys.

l Custom mounted side mirrors…. By Vision corp.

l Paint Color is PPG. Banana   ( Etching Primer. Base Coat. Clear Coat )

CHASSIS:

l Pro-Street 2”x 6”….  ladder bar frame . with coil overs. adjustable 4 Bar Link. Wheel Tubs. and safety drive line loop

l Rear End is a Ford 9” narrowed. 31 spline truck axles. 389 gears. big drum brakes in the rear. front disk brakes

l Drive line is a 1 ton truck shortened with heavy duty U-joints. and surrounded by a  ( Drive Line safety Loop)

l Front axle is Super Bell . with Super Glide leaf springs . Volvo spindles & Disk Brakes

l Rear Suspension is Alden Pro/Street and polished Coil Over shocks and Springs. Adjustable 4 bar link

l Floor pan is all . 250 thick 6061 T-4 Aluminum under carriage.

l Heavy duty welded motor mount towers.

l 6 point. sanctioned NHRA Roll Bar. with rear trunk struts… ( 2-1/2” )

l Ididit . Aluminum. Tilt Steering column with emergency flasher switch

l Flaming River Stainless Steel steering U-joints with . Reversed Corvair steering box

l 100 Amp mounted disconnect switch with a 1. 00 amp cranking battery ( trunk mounted)

Radiator:

l All Aluminum 3” core and 1” tubes

l Fan is 16”… 3000 cfm puller with a second 600 cfm 8” front mounted . pusher fan. controlled by adjustable thermostat.

Engine:

l 383 cu/in SBC. Block is a 1970 Chevelle SS. 4 bolt Main .  ( 9-1/2-1 compression ). 410 H/P at Dyno

l Dart Iron Eagle Heads with big valves. Aluminum hi/pro Rockers. Heavy springs. Stainless valves. Coated valve guides.

l Scat Crank. Ion-nitrated coated journals

l Aluminum Pistons. 9-1/2 x 1 compression. forged rods

l Cam is a Scat Cam. Street/Strip 4. 00-5. 00 rpm power band.  (a little loopy ) . … good Idle

l Induction is Edelbrock Performer manifold. Edelbrock 625 cfm Carb. and is a 4 barrel square bore with big secondaries..

l Ignition is all MSD… Super/Pro with 8mm wires

l Headers are Sanderson's cast aluminum block hugger. coated with S/S. never dull. never rust

l Exhaust is all 3” dia.

l Meladon. high volume oil pump

l Holly Electric Fuel Pump. 10 psi

Transmission:

l Hughes TH-350 Street Fighter…. Short Tail Shaft

l B&M. Hole Shot 2400-2800 stall Torque Converter

l Heavy duty front pump

l Short tail shaft

l B&M shift kit

l B&M .  Pro/Ratchet Shiftier

Interior:

l Upholstery is Grey Tweed & charcoal carpet. Trunk is also Grey Tweed & Charcoal Carpet.

l Seats are. Black Widow. Leather racing seats. Very comfortable & adjustable

l Classic Instruments in the dash with 5 overhead mounted gauges.

l Heater and ventilation is Vintage Air

l Roll Bar is 3” dia. .  ( 4point mounting to the frame )  painted PPG. Banana Pearl Yellow

l Radio is AM. FM. CD with a 300 amp amplifier. trunk mounted.

Tires/Wheels:

l Front tires are 6” x 14”

l Rear tires are 13' wide x 29' Goodyear Drag Radials.  The Car will accept up to 18” x 31” Micky Thompson Sportsman

l Wheels are all Weld Racing with . . .  4 Corner. 1970 Corvette Spinners.

Also published at eBay.com

Want to buy this car?